[mexking]

Mr. 10% took a couple of days lets see if it will work, cant log in but can post an answer

[mexking]

Check that the TA is not moving laterally  at set down and lift of, I had that on one of my decks, dont remember which one.

[mexking]

 

Keep it original, you can get your cartridge repaired here https://www.tonabnehmerservice.de/ I have gotten repaired various SP and MMC s there, good service and quality work

[mexking]

 

Here is what it looks like. I installed a micro switch 220v 10 amp on the steel plate below the switch actuated by the plunger that actuated the original switch, sorry no pics of that

[mexking]

Here a user sheet manual for the 2000

[mexking]

Good job congrats

[mexking]

I would start looking at the phono and tape preamp, Do the FM presets work OK

[mexking]

Checked the manual, you should be able to make one yourself its simple but considering the weight and that plastic over years gets brittle I wouldn’t trust the small pegs on the bottom cover of the 1200

[mexking]

These failures are difficult to find, one are always looking for component failures and at last it turns out to be something simple you dont think about, (except for Martin who have seen it all) good job, jeg er ekkoet

[mexking]

Here the text from this thread  https://archivedforum2.beoworld.org/forums/t/14600.aspx?PageIndex=1 Of what I did.

While I had all the sanding utensils out and ready, I started on the ugly acrylic cover, I placed it on a sturdy cardboard box that nearly fit into the cover Bad idea as I sanded with 30 micron the cardboard damaged the inside of the cover, I had to cover the box with a cotton rag, and later sand the inside with 15 micron and so on), I then wet sanded with a 30 micron sheet, parallel to the long side until the deep scratches was gone, the most difficult was the damage you can see in the first pics. I then went to 15 micron sanding parallel to the short side until all the grains from the 30 micron was gone, then down to 9 micron, long side, until all then grain from 15 micron was gone, then down to 3 micron, short side, I now had like a haze on the acrylic, not quite clear, I then took to Novus No. 2 scratch remover, and that did it. With 25°C in the garage this was a boot camp, 2 hours hard work, sweating like after a 5 Km run. I have some more covers where I tried with Novus No. 3 and 2 and 1, It didnt turn out as well as this one.

[mexking]

Hallo Christoph, Ich schlage vor, das du mit Dillen auf diese Forum kontakt aufnehme, Er kan sehr oft mit Ersatsteile helfen. Er ist auch der besitser von https://www.beoparts-shop.com/ und villeicht hat er teile die Nicht im Beoparts erscheint

[mexking]

I am in CDMX, have a working Beosound 3000 and cables that work, if B&O Mexico cant help you I can, living at “salida a Cuernavaca”

[mexking]

Here is what I changed in mine 2012, plus a lot of cleaning and adjustments, dirtiest unit I ever done.

[mexking]

I made copy pegs in my lathe, leveled the base, the pegs made with bigger “foot” and glued them to the base, will go and look for the speaker in my dungeon, if found I will post a pick

[mexking]

Find a wall plug correct diameter and cut length to size, glue on with good epoxy.             Clean and even base before gluing

[mexking]

Wonderful thread Evan, congrats to a very nice work, looking good

[mexking]

As Martin says or use an angled (90 degrees) screwdriver, in mine they were missing

[mexking]

Good find Jacques

[mexking]

All these melodies brings back sweet memories from my childhood. I am born 1950, my first memories is beginning mid to end of the 50es, one of these is Sunday 12:00 noon,  you wish we play, the Sunday Concert named Giro 413, giro 413 was a postal account number where you could pay money to help poor children and Red Cross and the like. We ( my family) had every Sunday 12:00 noon, family dinner as obligation, at the same time the radio was turned on to listen to Giro 413, every Sunday, the program lasted 2 hours and after that the radio was turned off again and only turned on for the news at 6 o’clock pm. every day. 1950 in DK there was only one radio canal, this changed with the years and today there are several, but Giro 413 has been going strong from 1946 until today the postal account number still exist as 01700413, but also internet pays and cell phone pay are possible. You can listen to it on DR.DK canal 5, I dont know the time of the broadcast you will have to check that yourself . Thank you Martin

[mexking]

Lovely memories from DK in the 50es 60es oh yes bring the march too, thank you Martin

[Author]

Posts