[NQVHNWI]

My view is that B&O as we know it now will be gone for good in 6 to 12 months.

This is plainly out of the current financial wave about to hit us all.  (I wrote about this a couple of months ago – before the current “conflict” which is not to blame but certainly an accelerant).

B&O will be a brand in name only – like Rolls Royce Motorcars was once and the name sold. A new set of products may emerge under new ownership but it will be detached from its current 95-96 year manufacturing history.

Sorry I cannot foresee a better outcome to all.

[NQVHNWI]

From a historical perspective, https://beocentral.com/ is perhaps the best site – however, it has not been fully updated of all products for the last few years.

Some products with colour variations or MK1 or Mk2 may be lacking in the newer products (Beoplay, headphones etc). However, that can be cross references with B&O’s official site for anything missing.

Edit: I would also add that the accessories – both Beocentral and Bang&Olufsen will be difficult to track down without a Service Engineer or a good Dealer as these were normally sold under the radar with Customers wanting more specialised and complicated “around the House AV” Setups.

[NQVHNWI]

I use quite an aging Xytel Multy X “mesh” system. 3 nodes from my Wifi Modem/router.

I see two networks broadcasted – one is the original Wifi Router Modem and the other is the designated name from the Multy master (which one unit is hard wired connected to the Modem/Router). All the Multy X broadcast the same wifi ID.

I connect all devices to the Multy X Wifi ID. All works perfectly and continuously across 3 floors and a stairwell.

I feel you need to configure your Mesh system to a similar setup. If you are using a number of old Routers (non-mesh), it is possible to get them in relay mode toggling the internal configuration. However, the BeoApp to me would not be the source of your problem here.

10

 

[NQVHNWI]

Flow State – Above and Beyond.

[NQVHNWI]

<h4>test for profile</h4>

[Author]

Posts