Jose

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: beovox 2200 6213 schema circuit crossovers #34318
    Jose
    BRONZE Member

      Hello again , I just want to modify the tweeters, the Celestion 4 ohm impedance, it’s a great speaker with 5″ woofer, equivalent to the Kef B110 sp1228 woofer, from the LS3/5A. The change of the Peerles tweeter of 4 ohms impedance, for other more modern and less directive dome tweeters, some of the philips ad0160, seas h107, audax models would be of another impedance value 6-8 ohms and cut equally between 2000hz and 5000hz , if the performance in dB is much higher, attenuate them with a two-resistor L-pad. I have found a circuit that may be from the Beovox 2200 6213 but it is not sure. Help for the modification. If anyone can help, it’s appreciated.IMG_20220423_124230

      in reply to: beovox 2200 6213 schema circuit crossovers #34317
      Jose
      BRONZE Member

        beovox ht 2200 6213

        in reply to: DIN Cable Question on 4002 #34311
        Jose
        BRONZE Member

          Those cables are good, and they don’t need to be changed, if they are well connected and the ground is in place, they shouldn’t give you any problems, check the internal connections and their soldering, just that and enjoy the music

          in reply to: beovox 2200 6213 schema circuit crossovers #34316
          Jose
          BRONZE Member

            And another question.

            I am making a change of tweeters in the Beovox 2200 boxes, Celestion 5″ woofer and I want to change for more modern tweeters from Philips ad0160, Audax, Seas,. Has any DIY hobbyist made these changes and modified or used crossovers to adjust to the new tweeters and their performance, ????

          Viewing 4 posts - 1 through 4 (of 4 total)