Ckbrookes

Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • in reply to: Help required – Beoremote One Hotel version #57055
    Ckbrookes
    BRONZE Member

    Hi

    o to have an hotel version, how did you get on resetting?

    col

    in reply to: Beovision Horizon #35010
    Ckbrookes
    BRONZE Member

    Hi

    Is that for Beovision 11 55 ?

    I haven’t done anything with it as yet because I wasn’t sure if it was the engine or the screen, I have fant coloured vertical lines that don’t always show up, only on certain backgrounds,

     

    kind regards

    col

    in reply to: Beovision 11 55 #46019
    Ckbrookes
    BRONZE Member

    Hi Jean

    yeah I have a few vertical lines, I have looked at the service manual it looks doable, but do we know make and model of the panel?

    kind regards

    col

    in reply to: Beolab 11 #39887
    Ckbrookes
    BRONZE Member

    Simon at AVA can’t locate one,

    cheers

    Col

    in reply to: Beovision Horizon #35006
    Ckbrookes
    BRONZE Member

    Hi All

    another question for the experts, what make of screen has the Beovision horizon 40 have, I’m going to attempt replacement my self ?

    kind regards

    col

    in reply to: Beovision Horizon #36311
    Ckbrookes
    BRONZE Member

    Thanks all

    for your help the BOApp worked ,

    but only to show me a crack LED Must of happened in storage!!

    is it worth getting a new screen?

    much appreciated

    col

    in reply to: Beovision Horizon #36307
    Ckbrookes
    BRONZE Member

    hi

    much appreciated, the green light only

    stays on for one minute and then goes blank

    ill have to find another beoremote one

    kind regards

    col

    in reply to: Beovision 10-46 – how to open the case? #34728
    Ckbrookes
    BRONZE Member

    HI All

    has anyone had a problem  with the Beovision 10-32 it turns on but no picture, I think there is sound ? the screen shows a very dim blue.

    any help would be greatly appreciated

    Kind Regards

    Col

    in reply to: Beolab 8000 #34830
    Ckbrookes
    BRONZE Member

    Hi

    I can’t give the serial as I put mk2 innards into a mk1 chassis every think was fine till a I took them apart again to re form ?

    Col

Viewing 9 posts - 1 through 9 (of 9 total)