redfox

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Tape stuck in deck! #41493
    redfox
    BRONZE Member

      That is good advice!

      Ki nd regards,

      Redfox.

      in reply to: Beocord 8000 – no power – won’t turn on. #45599
      redfox
      BRONZE Member

        The extra fuse is inserted and the Beocord 8000 now fully works. Plays fine. Thanks for the help!

        Kind regards,

        Redfox.

        in reply to: Beocord 8000 – no power – won’t turn on. #45598
        redfox
        BRONZE Member

          Thanks MArk,

          So I did, and discovered normal Ohm and closed circuits on the secondary side. All normal. Then there’s an extra fuse inside the transformer housing, a bit har to open. But that was broken into pieces. So stole the one from a pcb next to the tape drive, and it turns on 😉

          So, tomorrow I am out for fuses and see if the capstan will turn and thereby allowing the heads to stay in play etc. The solenoid moves the heads now, but retracts. Let’s say or hope, that is because of the fuse I removed. Belt looks fine and everything is clean inside. 3 capacitors on the pcb just behind the transformer, has been changed.

          Thanks for answering. Very kind of you.

          Kind regards,

          Redfox.

          And here’s the Beocord 8000, now with power on:

          så kører vi

        Viewing 3 posts - 1 through 3 (of 3 total)