Beocentre 2500 tape mechanism repair

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • #8187
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    916A1997-3114-4C18-927E-5DFD439BF159hi i have a late 80’s Beosystem 2500 – the tape mechanism suddenly stopped working – after new belts were fitted I noticed this spring was loose for the head mechanism – does anyone know how it attaches ?
    Thanks

    #8190
    spassmaker
    BRONZE Member
    • Topics Started 3
    • Total Posts 49

    Hi

    I’m not shure but maybe into the gap on the toothed levelarm above the last theeth and then a little right.

    Regards

    Christian

    #8192
    Guy
    Moderator
    • Warwickshire, UK
    • Topics Started 8
    • Total Posts 298

    I concur with Christian!

    spring

     

    #8193
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    Wow! Guys thanks so much that diagram is priceless!

    #8195
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    It’s hard to know how to set the lever arm into the head’s cog 🤷‍♂️

    #8196
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    As the head can spin 180 degrees does anyone know what position it should be in default ? if I look directly at the tape player from the front with the head at the bottom is the default position all the way to left or right position ?

    thanks

    #8199
    Die_Bogener
    BRONZE Member
    • Topics Started 1
    • Total Posts 67

    There is not one fixed position… there are 2 !

    It’s an “either or” position. The spring shall fix it in side 1 or side 2.

    It’s an over the peak snap construction.

    Just snap it in the gap next to the teeth…

    #8208
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    B1DC2FC7-5A2B-426F-A6C0-5099B71B6E34

    #8209
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    This does look right

    #8210
    Troy74
    BRONZE Member
    • Topics Started 1
    • Total Posts 7

    I understand there may no fixed position but I need to know how to mount the white plastic leaver and n relation to the head position

    #8227
    Die_Bogener
    BRONZE Member
    • Topics Started 1
    • Total Posts 67

    The gear does only the movement, the head has it’s own justage … see the red stuff? This is for the head position.

    The gear should only be in something symmetrical end position when switching side 1 – 2

    I think there is one tooth wrong… just 1 tooth in endposition looks a little bit weak overlap… how does ist look in the other position? 3 Teeth?

Viewing 11 posts - 1 through 11 (of 11 total)
  • You must be logged in to reply to this topic.