robert_glatzel

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Replacement gear for century 2000 #45968
    robert_glatzel
    BRONZE Member

      Wow, thank you so much! This is perfect. just placed my order.

      Thank you!

      robert_glatzel
      BRONZE Member

        Hmm unsure which part this refers to ( very new to this 🙂 ), but it’s the American one.
        I haven’t noticed anything working incorrectly, although I’ve only used it for cassette tapes.

        And great! I will go ahead and give this a try then!

        robert_glatzel
        BRONZE Member

          Ah okay thank you for the response!

          I’m unfamiliar with the names of the parts but I believe PCB 5 is the one after the transformer that sits under the door motor, correct?

          And 10 Mains seems to be the one where the power cable is plugged into and then has a wire that runs into the transformer, correct?

          I have switched both mentioned parts out for European versions, so I think if I were to change the wiring on the transformer it would work just fine…?

          in reply to: Looking for help with repairing a BeoSound Century 2000 #43339
          robert_glatzel
          BRONZE Member

            Oh great!

            Thank you for your replies!

            No, I did not check that board, as I only saw the smoke come from the bottom left of the unit. I will take a look after work.

            If I’ve replaced the transformer, the pcb in my photo, and potentially this piece, are there any other pieces that might need to be replaced?

          Viewing 4 posts - 1 through 4 (of 4 total)