Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Moonlight70

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Beogram 1202/1203 – Noise from idler wheel #52631
    Moonlight70
    BRONZE Member

    ……The motors metal bracket must not touch the nylon bushings ……… Martin

    Thanks Martin! I think the problem were there. The nylon bushings appeared to be fitted in the wrong order, so the opening space was too low. I compared with the quiet one.

    in reply to: Beogram 1202 Pickup gap #51894
    Moonlight70
    BRONZE Member

    Thanks Geoff! I will take a look at the pickup. I did set it to 2g, but I am not sure if it is SP10 or SP14. I tried to adjust the three screws for the platter-hight, but if I lower the platter, the pickup-arm stand also lowers. So the gap are constant.

    //Lars

Viewing 2 posts - 1 through 2 (of 2 total)