[ChristianSanden]

Problem to see the version at one of the 3500… Was justed displayed for some milliseconds… But the other showed me ver 1.1

/Christian

[ChristianSanden]

Thanks for all of your input. As you write Steve thats my purpose to make this work as you describe it. But something, I guess a setup, make both my 3500 to switch off within a few seconds after set mode to ”mcl”. This without touching anything. And if I chosse radio/tv etc it also switch off… The same for booth 3500 with 2 different beo4 remotes…

[ChristianSanden]

Thanks for the ideas. No lights or ir signals what I know. I can see that the 3500 seems to shut off if I select radio or tv or someels input after a short while. So maybe some generell problem on my system… not just when I try to choose mcl input

[ChristianSanden]

Correct – goes to standby after a few seconds. No buttons on remote or 3500 touched.

[ChristianSanden]

Thanks for your advise.

Someone who test ”soundsheavenlys” cable for beolab 3500 which uses mcl input? Seems to be one of their big selling cable. Noticed on theirs ( Steves) video that ”mcl set” Not disapear which it does for me. A trigger signal provided by the cable/beolab?
Have seen other videos that not have a cable connected and the ”mcl set” is left for a long time. So a setup? or what…

/Christian

[Author]

Posts