BV11 on BV10 Stand–how to wire?

[Gene Ku]

Looking for help with using a floor stand for a BV10 with my BV11 but the clips don’t match.

How do I wire these together? (I’m not sure I numbered them correctly according to standard convention, but BV11 #1 goes to which BV10 #, BV11 #2 goes to which BV10 #, which BV10 # is ground, et cetera?)

Thanks!

Gene

 

[Guy]

Normally I’d refer you to the service manuals (avail to Silver & Gold members), but here are screenshots from the relevant sections.  I am not convinced that it is straightforward but if you can get it to work please come back and let us know how!

BV11:

BV10:

Location: Warwickshire, UK

My B&O Icons:

[Madskp]

Guy wrote:

Normally I’d refer you to the service manuals (avail to Silver & Gold members), but here are screenshots from the relevant sections. I am not convinced that it is straightforward but if you can get it to work please come back and let us know how! BV11: BV10:

I would no be to sure that these stands are compatible. 12V on one vs 14V on the other. Two wires with twoway communication on one vs 3 wires with one way communication on the other.

You have to be very sure what you do if you try to combine these

Location: Denmark

[Gene Ku]

Thank you!

 

I know to be careful which is why I asked!

 

Is the numbering in the schematic the same as my numbering? I know there must be a convention, but I don’t know it.

 

Out of curiosity, is the Avant wired the same as a BV11?

 

Thanks again!

[Guy]

Gene Ku wrote:

Is the numbering in the schematic the same as my numbering? I know there must be a convention, but I don’t know it.

I don’t know, but from inspection you can probably work out ground, and maybe find the 12V (or 14V) using a multimeter and then have an educated guess for the remainder!

Gene Ku wrote:

Out of curiosity, is the Avant wired the same as a BV11?

Looks the same in the service manual – this calls the connector a ‘MicroFit 4-pin’, if that’s any help.

Location: Warwickshire, UK

My B&O Icons:

[Gene Ku]

Thank you!

 

I think this is exactly what I needed:

 

https://iisb-foxbms.iisb.fraunhofer.de/foxbms/docs/latest/hardware/connectors.html

 

 

[Beouser19]

Bv10 stand are NOT electrical compatible with bv11 stand

bv10 have turn left 5v and turn right 5v

bv11 use CAN bus serial data

[Gene Ku]

Thank you, Beouser 19!

That is a big difference. I haven’t tried anything yet and looks like I shouldn’t.

Is the stand from an Avant NG compatible with either BV10 or BV11?

[Author]

Posts