Home Forums Product Discussion & Questions BeoSound BS theatre, to much bass

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #44210
    Zwaan
    BRONZE Member

    system consists of 4x BL 3, BL 19, theatre. Tv LG G2
    especially with netflix/disney+ I experience too much bass. setting done through roomsence. what can i change
    what should crossover be on? and the various diversion levels?
    do hou have suggestions

    #44211
    NQVHNWI
    FOUNDER Member

    Leave the crossover – that will be set at 120hz but I doubt it is your problem?

    1. In BeoApp, on the Theatre front page, below listening position

    Sound >> Equaliser >> dial down total bass setting.

    2.  Go to a chosen Listening Position (Video >  say)

    Open the configuration and find “Speakers >”

    Find your BL19 registered, dial-down the dB. This will keep the overal tone but reduce the attenuation, giving a deep but less powerful bass

     

     

     

    #44212
    Zwaan
    BRONZE Member

    the equalizer Both in  minus 10?
    speaker level or redirection level. And value?

    #44213
    NQVHNWI
    FOUNDER Member

    Move the base equaliser to say -2

    Move the speaker level down as much as you can to suit your taste.

    I don’t know the effect of redirection level.

    sounds like your BL19 is not taking commands from the Theatre if the bass remains too much

    #44214
    kawo
    GOLD Member

    I had a simular problem with a Theatre I had for testing at home. My one was faulty and went back to B&O for repair. The Bass was by far to much.

    #44215

    Hi Zwaan,

    Welcome to Beoworld!

    First, I suggest you turn off Loudness in the B&O app, then either set bass to -1 and treble to 0, or set bass to 0 and treble to +1. This should give a good sound balance with the Theatre for most setups, then tweak the sound from there to suit your ears and preference.

    Kind regards, Steve.

    Location: The cable workshop, England
    Favourite Product: Beosystem 72-23
    Signature: Cables, friendly advice and great ideas for connecting Bang & Olufsen! Ask any questions at https://soundsheavenly.com to get the best from your B&O! Please visit my B&O YouTube channel at https://www.youtube.com/soundsheavenlycables
    My B&O Icons: No description available No description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description available No description available No description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description available
    #44216
    geoffmartin
    BRONZE Member

    Some things to try (including some repetition from the above):

    • Don’t change the crossover
    • Don’t change the Re-direction Levels (as a first step, at least)
    • Don’t turn off the Loudness

    Find an example of a signal that you feel has too much bass. Play it and disconnect the power to your Beolab 19 and play it again.

    IF, when you do this, the issue disappears (I assume that this will over-compensate and now you have too little bass), THEN
    the solution is probably to reduce the Speaker Level of the Beolab 19 in the Listening Position -> Speakers menu. There’s no way to predict how much you should reduce it. Just drop the level until you’re happy with the relative balance.

    However, IF, when you do this, the issue is still there, THEN
    the solution is probably to reduce all Bass Redirection levels. Do this to all of them by the same amount (e.g. drop each one by 1 dB and listen again…. repeat this until you are happy with the relative balance.)

    Hopefully, one of these two procedures will fix the issue for you. After this, you can use the Bass, Treble, Frequency Tilt, and Sound Enhance sliders to make fine adjustments to taste.

    Hope this helps.

    Cheers
    -geoff

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.