Home › Forums › Product Discussion & Questions › BeoSound › Beosound Core – Optical-In to TV not working
- This topic has 6 replies, 3 voices, and was last updated 8 months ago by Millemissen.
-
AuthorPosts
-
3 April 2024 at 03:26 #54069
Hi B&O Dreamers,
I have a setup (see below) including a Beosound Core as end piece to a TV via an Optical cable, but no sound comes out of the BL18 speakers. Any ideas how to make it work?
I tried to change the source on the B&O Mobile App to Optical-In and still no sound.[BL 18] via WiSA << Transmitter 1 >> [BL 18] via WiSA
^
PowerLink RJ45
^
Beosound Core
Optical-In
TV3 April 2024 at 19:26 #54070Did you set the sound of the tv to PCM/stereo – and to output from Toslink – in the settings there.
Please be aware!
Depending on the tv brand this might be named differently in the settings.MM
4 April 2024 at 06:56 #54071In my case, I connected the SONY TV to the Transmitter 1 and the TV automatically switches to Optical output and plays sound. Using Transmitter 1 is not option because I could not lower the minimum volume which is too high. The Optical out min volume could not be lower by the TV too.
But if I switch to the Beosound Core, no sound comes out.7 April 2024 at 19:13 #54072The Beosound Core actually has only Optical-Out port.
Topic to be closed…
7 April 2024 at 22:05 #54073The Beosound Core actually has only Optical-Out port. Topic to be closed…
Really?
MM
8 April 2024 at 20:30 #54074The Beosound Core actually has only Optical-Out port. Topic to be closed…
Isn’t it optical INPUT?
8 April 2024 at 22:45 #54075Sure – that is the combined analog/digital input port, that is available on many ASE-based devices.
Just to prove that Paul Jordan was wrong ? about the BS Core.
MM
-
AuthorPosts
- You must be logged in to reply to this topic.