Beoplay M3 line in sound skipping

[Peter8300]

I’m trying to create a setup where I connect a Beogram to a Beoplay M3 via line in and then do multi room to a Balance. The M3 is only supposed to be the gateway to the balance.

However the sound is skipping all the time, so the setup is basically useless.
If I disable delay in the B&O app the M3 plays just fine, but then I cant do multi room…

Any ideas?

[Guy]

Hi Peter and welcome to Beoworld!

Have you tried changing the Line In detection level to ‘disabled’?  It’s the setting above the delay setting.

 

Location: Warwickshire, UK

My B&O Icons:

[Peter8300]

Hi Guy,

Thank you.

No haven’t tried that, will do so when I’m back home tomorrow and report back.

I spoke with B&O support today and they suggested that it could be due to my mesh network..

Thanks
Peter

[Peter8300]

After disabling my mesh network and just going with one router everything now works fine.

[Guy]

Peter8300 wrote:

After disabling my mesh network and just going with one router everything now works fine.

Good to hear – I hope it keeps working!

I meant to say, it could also be worth checking that your M3 is at the latest SW level – it should be at 6.5.57689.212515568 which was released on 22 October 2025.  Full details of this and earlier versions are listed in the release notes here:  https://update.bang-olufsen.com/products/b4ebddbebc6542ad87534e36f49d6a9a

Location: Warwickshire, UK

My B&O Icons:

[Peter8300]

Guy wrote:

Peter8300 wrote:
After disabling my mesh network and just going with one router everything now works fine.
Good to hear – I hope it keeps working!

I meant to say, it could also be worth checking that your M3 is at the latest SW level – it should be at 6.5.57689.212515568 which was released on 22 October 2025.  Full details of this and earlier versions are listed in the release notes here:  https://update.bang-olufsen.com/products/b4ebddbebc6542ad87534e36f49d6a9a

Thanks.

Yes the software is fully updated.

[Author]

Posts