Hi:
I have a Beolink 7000 remote that has started to turn on and off by itself when sitting in the recharge craddle.
I will put it into standby mode, it will turn off and then turn on again.
When powered on, it functions properly including the two way communication.
I have looked through the threads in both archived forums. They some very detailed information about recapping and display illumination, but I could not find a thread that covers this issue.
I prefer not to blindly recap the remote.
If I missed a relevant thread, could someone direct me to it? Otherwise, any ideas where I might try to look?
There is a copy of the service manual from Beoworld.org but there are no schematics other than the charger.
Thanks,
Derek
.
