Beogram 2000 (same as 1203 or 3000) Type 5240: arm come back before lifting

[guigui37]

Hi

it’s been a long time since my last post here 😀

Well, just got a Beogram 2000 which was very sick… with totally blocked motor (fixed easily, I became quite an expert in this exercice 😂)

Now it’s running really good but I have a problem I can’t solve: at the end of the disc, the arm starts to come back just a little bit before lifting up 😓😱… then it lifts and come back correctly : this is terrific for the stylus and the disc.

Does anybody now how to solve this ?

Maybe I have the answer in the coming sentence : the arm is moving a lot at its base, I believe it comes from there but I don’t know how to reduce this that movement, ..

[guigui37]

Just got the arm correctly adjusted (like my other Beogram)…but I still have no solution, no idea: arm returns back a little bit before lifting 😭

• This reply was modified 3 weeks, 4 days ago by guigui37.

[guigui37]

[Peter8300]

Try to take off the cam wheel and clean it thoroughly with water and soap and/or isopropylalcohol. All the levers should move freely including the cobber ones. There should be NO grease or oil on it.
That has helped me more than once.

• This reply was modified 1 week, 4 days ago by Peter8300.
• This reply was modified 1 week, 4 days ago by Peter8300.
• This reply was modified 1 week, 4 days ago by Peter8300.

[guigui37]

I was going crazy… then I read your post.

Removed the cam wheel… dropped it in my ultrasonic cleaner with detergent and heat…

Dried it…

Got it back … and the dream came true 😃😃😃😃

So happy, the turntable runs like a brand new one !

So many thanks for you help.

The cam wheel was not looking greasy but yes it required to be deeply cleaned… basically.

Many many many thanks again 👍🏻👍🏻👍🏻

[M J Vink]

The shaft of the lift mechanism might come up too slow, so grease it and make it move correctly

Location: holland

Favourite Product: beogram

[guigui37]

Thank you for your answer, on that side : it is working good.. correctly greasy. 😉

[Author]

Posts