Home › Forums › General Discussion & Questions › beogram 1202 teeth on spindle gear worn
- This topic has 2 replies, 2 voices, and was last updated 5 months, 4 weeks ago by spassmaker.
Viewing 2 posts - 1 through 2 (of 2 total)
-
AuthorPosts
-
31 October 2023 at 13:27 #2388
I just got a 1202 and the teeth on the spindle are very badly worn and it doesn’t engage with the arm mechanism. I am trying to remove the spindle but it seems to beheld in place by rivets! Any ideas on how to remove it? and where I might get a new gearing from???
1 November 2023 at 14:02 #21106Hi
You are right, the spindle is held by a rivet and only to remove with some pulling on the rivet
I’ve a complete spindle / hub in my workshop, all teeth are ok, rivet is attached send me a pm.
Kind regards
Christian
-
AuthorPosts
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.