Hi!
This is my first post so please forgive any netiquette faults!
I work as a volunteer in a Repair Cafe. A client recently brought in a
Beogram 1202 turntable that wasn't working. I fixed the whole motor/arm
combo and it is now working.
They also showed me the (half-disassembled) lid that they had. I
(foolishly?) offered to try and fix that too. I find that there are
two, handed, long (torsion bars?) that, I guess, counterbalance
the lid as it's being opened. I can't see how they fit. There is a clamp
in the frame that enables the bars to be inserted by sliding
the pins in. They can be inserted in 'Pin up' or 'Pin down' mode. Which?
Does Torsion bar A go left or right? How does the torsion bar fit into
the end plate?And, finally, why are the little washers -
that do go on the torsion bars - strangely slotted. I'm puzzled! Can
anyone help? Thank you very much.
I have pictures that make all this much clearer, but Beoworld doe not seem to allow pictures to be attached to posts. Sorry.
George May
