Home › Forums › Product Discussion & Questions › Other › Service Manual for low floor standing rotating tv stand
- This topic has 9 replies, 2 voices, and was last updated 2 weeks, 5 days ago by stotty1111.
-
AuthorPosts
-
24 September 2024 at 08:40 #59329
Hi all,
I have a low stand under a BV 10-40, I am trying to access the wiring in said stand as the ali disc is badly marked I have a good one to install, but don’t know how to access the wiring connections.
Anyone out there can supply details or links please?
Tony S (France)
24 September 2024 at 10:03 #59337If you just want to replace the aluminium disc then I think you should be able to do so without disturbing any of the wiring. Have you tried removing the moving bracket parts at the top of the stand (allen key required) and then simply lifting the disc up over the pole. The cables should just tuck into the cable gap in the pole while you do this.
Failing this, you can go under the stand base and unbolt the vertical pole, then feed the cable down through the pole as you remove it – again no requirement for any wiring to be disturbed. I am not sure about the 10-40, but many B&O motorised TV stands also have a DIN connector within the pole for easy disconnection.
This may help: (You should be able to remove parts 9515 and then 9514 quite easily)
24 September 2024 at 11:41 #59339Thanks for that Guy!
No , I think I will need to access the connections as the plug at the tv end is broken, so, I either need a new plug to mount myself or a complete cable.
Do you have any info about the tv end plug?
24 September 2024 at 12:08 #59340This from the service manual:
And an old post here talks about stand cable colours BUT it actually refers to the older round (DIN) stand connector – B&O may have kept the same colours scheme.
24 September 2024 at 12:48 #59341Again, thanks, the plug is broken in half so to speak, and, it is possible to see the wire cover colours.
So it would seen to be a fairly simple job to mount a new plug.
I had found some plugs linked to Amazon, so , later I will have another look!
24 September 2024 at 17:20 #59344So, the wire colours are
1 Black
2 Brown(?)
3 Red
4 Yellow
5 Qrange
6,7 and 8 not connected!
24 September 2024 at 17:40 #59345As far as I can see this should work, just need to solder the joints and heatshrink coloured covers on them — it will not be pretty but should work!! 😉
3 November 2024 at 17:05 #60697Going on from this, did B&O ever market any sort of plug to fill the shelf mounting point on the vertical tube when the shelf was not used?
3 November 2024 at 19:06 #60701From the BV7-32 service manual – see part 9517 below:
4 November 2024 at 07:09 #60703Thanks for that Guy!
Next question, are they still available or am I on a quest for hen’s teeth / rocking horse droppings?
I’m looking for 2!!
-
AuthorPosts
- You must be logged in to reply to this topic.