Home Forums Product Discussion & Questions BeoGram Bg 4000 tonearm behavior

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #40997
    bulldog123
    GOLD Member

      On an otherwise fully functional Bg 4000 5215  I am getting the following behaviors:-

      1) when pressing the ^ button the tonearm does not stay up once the ^ button is released – it just drops as if the down button had been pressed.  Same behavior on < and > buttons – is this a keypad problem or should I be looking elsewhere?

      2) from time to time the tone arm drops suddenly instead of the normal smooth drop that is expected. This is not a persistent problem.

      Any thoughts and guidance greatly appreciated.

      #40998
      spassmaker
      GOLD Member

        Hi

        Cold be a keypad problem, regarding to the SM the \/ button is normaly closed and the /\ button is normaly open.

        So as there is a bad contact at the \/ button the tonearm will only stay up as long as you push any other button.

        Cleaning the contacts is recommended, look here for further information:

        https://beolover.blogspot.com/2017/10/beogram-4004-type-5526-keypad-contact.html

         

        Kind regards

        Christian

        #40999
        bulldog123
        GOLD Member

          Thanks Spassmaker I will look at that.

          #41000
          hcraig244
          SILVER Member

            Just spotted this post justin, picked up a chest infection from soewhere ;¬(

            The tone arm dropping sharply sounds like not enough dampoing, try winding the srew in very slightly…..and I would check out the down switch contact…..if its playing up the tone arm will dot stay up when ^ is pressed

            #41001
            bulldog123
            GOLD Member

              Great Craig.  Thank you.  I hope you make a speedy recovery.

              #41002
              bulldog123
              GOLD Member

                Fixed.  Thank you Craig and Christian.  The down switch contact terminal was oxidized and bent – after cleaning and straightening it works a charm.  Tone arm is dropping smoothly now.  Sweet sounds are emanating from the deck and its owner.  Thanks again.

              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.