Beocenter 9500 Co.de

[spassmaker]

Hello dear Members

I know it’s about the Million Times asked for the Co.de for a Beocenter 9500

 

With a new Lithium Battery tested.

I’ve read already to:

Plug in the Center

Type 1271 with Beolink 1000 or Beolink 4

Unplug the Unit and plug in after about 3 seconds.

So far so good but it does not work this time.

Tested other Codes like 1270, 1207

Have already tested several BL 1000 and BL 4, no succsess.

Checked already the IR Signal to uPc board IC3 PIN 3 > Ok, signal clear present. Measured with Oszillscope.

What can cause this behaviour?

Hope to get an answer or a solution for that Problem.

Kind regards

Christian

 

 

[Guy]

It’s a long time since I have done this, but I seem to recall that leaving it at standby for a hour or so before trying the Code procedure may help.  It’s not logical but perhaps the unit gets used to the new battery?

Location: Warwickshire, UK

My B&O Icons:

[Author]

Posts