[vlad77]

Hello, i tried to find some manual how setup the shift on the beo4, i have searched all the forum of beoworld, no information how to do this.

 

 

[vlad77]

Hello, i have the service manual allready , i know that i need to start test mode. I found the  manual : https://forum.beoworld.org/forums/topic/beosound-9000-no-spinning-test-mode-result/

Test Mode for CD mechanism test. I put the BS9000 in Test Mode with a Beo4 (Shift>9>0>2>5>8) and run #27 to test the CD mechanism.

BUT.

i don´t know how to set up the Shift on my Beo4. Without this i can´t proceed with the test mode.

Best regards

 

• This reply was modified 1 week, 3 days ago by vlad77.

[vlad77]

excuse me, the second picture is right, i will try your instruction after New Year’s Eve, thank you very much!  i hope it is the solution! ))

for the case is not working, because for example, the communication between BS9000 and BLC is not working (hardware problem).

How to check in the service report log file and where to find the registration about communication between BS9000 and BLC?

Best regards Vlad

 

[vlad77]

Hello, i use only Beolink Converter NL/ML. the picture is from Internet. I have one with Cinch / RCA input, like on the picture.

[vlad77]

Hi there, i have replaced the SMD capacitors on the Masterlink board in the BS9000 before connecting back in the system and have tried every instruction  i have received from you guys, but… the BS9000 is still not visible in the Masterlink Gateway and I don´t have the sound.

I have tried :

disconnect everything from the mains
i have set up the BS9000 with beolink 4 to A.Option 0.
there is no reaction on Beovision 11 tv to setting option V.OPT 2 with beolink 4
there is no option like this to set up Beovision 11 tv to setting option V.OPT 2 with BeoRemote one.
If I choose CD with beoremote one I hear radio, same if I choose radio with the remote.

I post some pictures from setup Masterlink Gateway, I can´t find anywhere the BS9000.

I have created the service report as archive XXX.tar.gz file. But i don´t know where to find the communication between Masterlink Gateway and BS9000 in this report?? Or what is name of this file including communication report??

[vlad77]

you are right, the setup is like this

[vlad77]

ok, will try this first, thx

[vlad77]

I have the Beovision 11

[Author]

Posts