sashua

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Beolab 18 – New owner with questions #52016
    sashua
    BRONZE Member

      OK I am doing my installation later this week!

      Only question I still have is regarding my digital source. I have the Chord Hugo2/2 Go combo and it has a Gigabit (GbE) ethernet wired connection but I can’t use that, right?

      Looking at the manual I am getting a little confused since it looks like those speaker ports are only for Powerlink or Service so I guess I can’t wire directly?

      If I use Toslink for a direct connection to my DAC then it’s fairly confusing. Do I connect the left speaker to the right one and then the right one to the Hugo2?

      Any advice?

      in reply to: Beolab 18 – New owner with questions #52012
      sashua
      BRONZE Member

        OK inching closer thanks to all of you!!!!

        So use the preamp outs L+R front channels to the speakers and set them to L and R respectively?

        And for my center channel, sub and rear channels (currently KEF speakers but plan to upgrade to B+O) I just leave them as-is, hooked up to their speaker terminals on my preamp.

        Will my preamp just know to send the front signals out of the pre-outs and the rest of the speaker signals through the speaker outputs?

        Will the preamp volume control know how to equalize everything for volume levels or is that a system menu thing on my preamp?

         

        in reply to: Beolab 18 – New owner with questions #52009
        sashua
        BRONZE Member

          So I suppose the RCA inputs are a better choice than using the Toslink in your opinion?

          I am trying to understand how it all works together. I have a 5.1 setup. My rears, sub and center are still going to run off my amplifier but the 18’s will be independent and run off the pre-outs with their internal amps?

        Viewing 3 posts - 1 through 3 (of 3 total)