[rdirkse]

Hi Glitch,

Indeed the “set-down” position is a little off and need some adjustment. I read this is done by adjusting the eccentric disc near the mounting points for the rope and spring. I didn’t know this was adjustable and assumed it was just a guiding roller so didn’t pay attention to it before.

So I will have some more work on it and hope it can be adjusted by just lifting the back cover.

The sliding chassis parks without chatter but is also a little off to the left I assume that also has to do with the “set-down”adjustment.

Ralph

 

[rdirkse]

Hi Glitch,

I’ve managed to fix it with a plastic pole glued in the hole!

Greetings

Ralph

[rdirkse]

Hi Glitch,

I’ve managed to fix it with a plastic pole glued in the hole!

Greetings

Ralph

[rdirkse]

Yeah I think you are right, indeed bad design. I wonder how many of these end up broken. (Nothing about it on this forum)

I ordered some plastics from a Chinese webshop which I think will fit and try to glue that on.

I’ll post pictures of it when fixed.

Thanks again.

Ralph

[rdirkse]

Hi Glitch,

Many thanks for sharing your knowledge on this.

I also was under the impression the post was molded as part of the sliding chassis but I’ve seen other pics from sellers of the whole chassis where it was missing too.
So your answer learns me it is indeed a separate part which will most likely be missing on most others you can buy.

So yeah, I will try and make a new custom post that fits into the existing hole.

Thanks!

Ralph

[rdirkse]

Hi Martin,

I have attached a picture of mine now en I think it is broken compared with the pictures from the internet.

I can’t find just this piece of plastic as a part only the whole arm assembly.

Does any know where to find this part?

Thanks
Ralph

[rdirkse]

Hi Glitch,

Have you been able to fix the issue? I’m asking because I might run  into that issue whilst fixing mine. I have a question you might be able to answer about the wire/rope that moves the sliding chassis. From attached picture found on the internet (and also from your video) I can see a mounting point to attach the wire/rope

My sliding chassis just has a hole there en nothing to mout the wire on. Is this a removable part that I’m missing or is it broken on my chassis?

Hope you can help me out with that.

Thanks in advance!

Ralph

 

 

[rdirkse]

Inmiddels gerepareerd! Onderdeel was niet afgebroken maar het was losgeschoten waarschijnlijk tijdens transport.

[Author]

Posts