Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

on4dag

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Beogram 3000 5901, motorcontrol schematic #47543
    on4dag
    BRONZE Member

    Hi Mark,

    thank you for your remark. I have seen some posts on this topc and I am thinking of doing this (“oil-vacuum”) as well. But first I had to check if the other parts were all doing well.

    Thanks for your help.

    in reply to: Beogram 3000 5901, motorcontrol schematic #47541
    on4dag
    BRONZE Member

    Thanks all for your help.

     

    I have a question on the main bearing (nylon fitting) but I will make a new topic / post

    in reply to: Beogram 3000 5901, motorcontrol schematic #47539
    on4dag
    BRONZE Member

    I have reinstalled and motor is functioning!

    Motor makes still some noise, from the brushes. So I have to look if these are still available.

     

    in reply to: Beogram 3000 5901, motorcontrol schematic #47538
    on4dag
    BRONZE Member

    Hi Mark,

    I had a blown fuse and only the motor module caused this.

    I have tested the motor and it runned but with noise. Now I have re oiled the bearings but didn´t test the whole again. Can dry bearings cause an overcurrent to blow the fuse? If so, then I have to install it again and test it. What is your experience?

     

     

    in reply to: Beogram 3000 5901, motorcontrol schematic #47536
    on4dag
    BRONZE Member

    Some photos of the situation.

     

     

Viewing 5 posts - 1 through 5 (of 5 total)