[Philip Pedersen]

Thank you once again for your feedback. I ended up simply mirroring the gramophone cable. So left to right is white to first pin, red to second pin and then the combined shield wire of white and red goes to the third pin. As Peter mentioned, it is also crucial to solder the inside and outside wires of the yellow cable (shield) to the metal part of the cable itself – just writing this for anybody stumbling upon this thread in the future 🙂 Thanks again!

[Philip Pedersen]

Hi all. Thank you very much for the kind feedback! An archeive such as Peter Pans diagrams was exactly what I was hoping for.

I only have 5-pin female DINs available which should be sufficient?

Any major differences in the diagram from the 7-pin? Does do numbering scheme change?

[Author]

Posts