Hello all, I am new member, and I have a pair of Beolab 8000s with a 11xxxx serial number of which one I believe has the same issue as discussed above:
- when I use it with a Beolink cable, it turns on (and off) just fine
- when I use the LINE in, it works fine for 2-3 hours, and then turns off. It does not turn on again. (only if I change to Beolink..) When I remove the wall plug and wait until the next day, it works fine again for 2-3 hours…
With turning on I mean that the light switches from red to green and it plays music.
I have the disassembled speaker lying on my desk already as I am doing the foam replacement (thanks to this great forum!).
I don’t have electronic testing equipment other than a good multimeter.
Do you think I should be going for the IC1, too? Or any other part to consider?
Thank you!
