Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Home Forums Product Discussion & Questions BeoMaster Trimpots Beomaster 1200

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #54021
    Squidge1825
    BRONZE Member

    Hi there,

    I have finally gotten round to exchanging my Trimpots from the wonderful kit from Dillen.

    I was wondering if anyone has some advice on setting the new ones up. As I have a few questions.

    1. I have read its best to measure trimpots out of circuit. How do you then get an accurate reading once installed? In the manual it looks like one should take readings from the corresponding resistors once installed?
    2. In the schematics, for the 22k trimpot (No 100) it says adjust it for max VTVM reading. Am I correct in thinking that I cant do this with a normal multimeter? If not how can I go about settign this trimpot correctly.

    Thanks in advance guys

    Matt

    #54022
    Dillen
    Moderator

    Dont’ use readouts of old and bad components for reference!

    Set the new trimmer in its center position, fit it and refer to the servicemanual for
    the corresponding measuring points and correct settings.

    Martin

    #54023
    Squidge1825
    BRONZE Member

    Ok great stuff thanks.

    With regards to the max VTVM reading? How does one take that?

     

    Cheers

    #54024
    Dillen
    Moderator

    Not sure what you mean?
    VTVM usually refers to a Vacuum Tube Volt Meter (F.e. Bang & Olufsen RV9/RV11 etc.,
    but today most digital meters have a suitable high impedance so will work fine for most readings of this type.

    Martin

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.