RX-2 tonearm wirering

[Peer Grønnerup]

Hi,

I had to dismount the tonearm to fix a broken piece of plastic but did not pay attention to the 5 wires which is soldered onto the small board.

How on earth do I make sure i solder them back on correctly?

I quess I cannot just connect them randomly.

Maybe one of you guys now how the 4 sockets are to be soldered?I should then be able to measure which wire is connected to which socket in the end where the stylus is connected.

Attachments:

You must be logged in to view attached files.

[Mark-sf]

Observing from the front and comparing to a clockface:

12 = L

3 = R

6 = LG

9 = RG

You will need to use an ohm meter to identify which wire is connected to which pin.

[Peer Grønnerup]

Thanks Mark 🙂

 

[Author]

Posts