MX8000 SW1.4 Serice Menu with hardware mod - where is J40 - BeoWorld Forum

This topic has 0 replies, 1 voice, and was last updated 11 hours, 9 minutes ago by Roland Wilke.

Viewing 1 post (of 1 total)

Author

Posts
11 April 2026 at 15:42 #123277

Roland Wilke
BRONZE Member

Hi,

we did disassemble the MX8000 and according to the manuel on PCB1 at A11 the J40 should be the one to get into the service menue (via service pin / bus ignore mode) but only a testpad is at this position. Any idea where the correct pin is to get into the menue?

Thanks a lot
Author

Posts

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.