Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Home Forums Product Discussion & Questions BeoMaster Blown Beomaster 8000

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #57487
    Ary
    BRONZE Member

    Hi there dear members of Beoworld.

    I am very new to the forum and actually posting on it so I hope this post is in the right place.

    As you can see from the title my dear Bm 8000 gave up by sending a big bang through the speakers and a cloud of smoke hanging above the amp….. Ow dear….

    I put the amp in service mode and could quickly see that PCB 5 (Right output amplifier board) and PCB 6 (power supply) have blackened burnt capacitors.

    After the big bang, whilst I was quickly reaching to pull the power cord the display was still fully functioning and my girlfriend was able to turn down the volume.

    Now my question is what would be my best course of action?

    What tools would be beneficial to me to do a proper restoration on this unit if that is even possible.

    #59227
    Peter
    FOUNDER Member

    Just seen this – it depends on your own technical abilities – there should be a service manual available of site – I am pretty sure I scanned it for the old site and that will give capacitor values and positions so that they can be replaced. Otherwise I would entrust your device to a good repair shop – a couple of my items are with Multicare as I type!

    My B&O Icons: No description available No description available No description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description availableNo description available No description available
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.