Home Forums Product Discussion & Questions BeoMaster Beomaster 1900 ( it just stays in standby mode)

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #52669
    camiloastu@gmail.com
    BRONZE Member

      Hello,

      I am working on a Beomaster 1900 and when I power up the equipment, only the standby light comes on, and the relay click is not heard. What should I check or replace to solve the problem?

      Greetings

      #52670
      Dillen
      GOLD Member

        No relay click when you select a source?
        Front panel correctly fitted? – If the bronze forks under the front panel does not grip
        each their little pin on the circuit board, the touch fields will not work.

        Martin

        #52671
        camiloastu@gmail.com
        BRONZE Member

          Hello Martín Thank you very much for your response, the device only keeps the Stand by LED on, I cannot select any source. The front panel is not installed. Greetings and thank you very much for your help

        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.