Home › Forums › General Discussion & Questions › Beolab 8000 Won’t Enter Standby?
- This topic has 0 replies, 1 voice, and was last updated 6 months, 2 weeks ago by Robbie010.
Viewing 1 post (of 1 total)
-
AuthorPosts
-
16 May 2024 at 08:16 #55669
I tried posting this in the Beolab sub-forum but I’m getting no response so re-posting here…
I have recently refreshed a set of Beolab 8000’s. They both had faults so I opened them up, cleaned out the old perished foam and thoroughly cleaned the PCB’s etc.
Both have been re-damped and now function and sound great but one of the speakers refuses to go in to standby when the signal stops.
I have read and searched and searched but all of the power issues seem to centre around the speaker not functioning with a bad standby trafo, so not the same issue!
Help!
-
AuthorPosts
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.