Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Home Forums General Discussion & Questions General Discussion & Questions Beogram 5500 start stop microswitch not doing anything.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #70010
    mark. hinks.
    SILVER Member

    Hi I’m currently working on a beogram 5500.

    I’ve cured a lot of problems but now I’m stuck.

    The middle of the 3 micro switches doesn’t do anything.

    I have another 5500 to compare movement etc.

    I can here it click in and out but I’m unsure how to test it properly. plus

    I’ve had a look on the schematic but I’ve got totally lost as to what parts may need replacing if they are stopping the microswitch working.

    Any help appreciated.

     

    Regards

    Location: United Kingdom
    #70020
    mark. hinks.
    SILVER Member

    okay scrap the previous post ..  it was  the the centre weight detector not going down far enough.

    Any way to adjust that?

    what happens now is it spins normally for a few seconds but the small lift cam rotates around to almost the start position .. record on or off .

     

    Location: United Kingdom
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.