Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Home Forums Product Discussion & Questions BeoGram Beogram 4002 – Power off when not in use?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #56437
    ajames
    BRONZE Member

    This might seem like a dumb question but I would be grateful for any advice.

    I use my Beogram 4002 in the morning sometimes, the afternoon or the evening. I usually turn it off at the mains as I understand there are components in there that remain powered up all the time. I am causing more harm turning it off at the mains than if I just leave it switched on all the time and only switch it off at the mains if I am not going to use it for a few days?

    #56444
    Mark-sf
    BRONZE Member

    I would not bother turning it off at the mains daily or even a few days as this stresses components that were intended to have power on continuously such as the those in the power supply. I would only do it for extended vacations of weeks to protect from power surges. Using the 4002/4 models for almost 50 years this way without an issue.

    #56448
    ajames
    BRONZE Member

    Great, thanks Mark, very much appreciated and puts my mind at rest.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.