beogram 2200 motor problems

[Marc Verheijen]

i’ve bougt a beogram 2200. it doesnt run. I took the disk of.  when  i get the power on i saw a little movement but nothing more. when i get the belt of and puts the power on the motor just spins for a second, 3 or 4 turns and then stops. the lioghts are on and all but the motor doesnt turn. when i get power off and then on again it repeats again and again: the motor turns for only 3 a 4 spins and then stops

any suggestion is more then welcome. what could be the issue? What can i do?

• This topic was modified 1 week ago by Marc Verheijen.

[Dillen]

Record on the platter?

Martin

[Marc Verheijen]

hi martin

yes, also with a record on the platter it has the same issues

electricity is ok

when i turn the platter by hand, the beogram proces for staring and stopping works perfectly

only problem, the motor doesnt spin

 

[Dillen]

Check the start switch. These switches are known to oxidize and lose contact, particularly if not used for a long time.
Check for cracked solder joints where connectors are soldered to the circuit board.
All OK? Check voltage on motor leads.

Martin

[Author]

Posts