- This topic has 1 reply, 1 voice, and was last updated 2 years, 8 months ago by
Viewing 2 posts - 1 through 2 (of 2 total)
-
Hello Beoworlders,
When I short-circuit the test mode pins on my Beocenter 9000, the display first shown code 5.2.
I then performed a RAM deletion following the instructions of the service manual.
After that, the display shows 5.1
What is the meaning of these codes?
Kind regards,
Yann.
Location: Brittany, FranceMy B&O Icons:
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.