BeoCenter 2 master unit

[T1MV4N]

Good afternoon all, after spending hours sifting through this forum, and the archived ones, I still can not find an answer to my question.

I recently got a BeoCenter 2 system with BeoLab 2 and 3. It belonged to my Dad where it was sitting [unused] for several years (!!).

The master unit itself lights up with a red dot, and the keys all make the clicking sounds, but absolutely nothing else happens (doesn’t open, no menu shows up, etc). I have tried connecting and disconnecting all cables, to no avail.

Any help would be much appreciated. Thanks.

Tim

 

 

[Stoobie]

If the unit has been disconnected it is likely that you need to put in the pin code. (unless pin protection was disabled before it was last disconnected).

Stoobie

My B&O Icons:

[T1MV4N]

Hi there, thanks for your response.

If a PIN code is needed, wouldn’t it display that…? I assume it’s a 4-digit code, that was given along when it was bought?

I asked my Dad about it and he had no clue it even had a code, or that that was even a feature.

[stotty1111]

When first plugged in is there not an indication on the inbuilt screen , 4 x * if so try inputing 4 x 0, that might work, the other route might be to contact b&o with the serial number and an explanation , they have in the past given me the original pin code

[Author]

Posts