Maybe I have a severe case of Cabin Fever...

No promises, but if you could send a scan of the PCB + Schematic + some good quality photos and even a scan of the underside of the board if possible, and the critical measurements...

It might take me a while, it might take me fornever. 

Brand new replacement PCBs for the output amplifier boards would be nice. I haven't had much of a problem restoring those but I have seen photos of other people's output amplifier boards that probably were burned enough to be suspect. I would be interested in trying out a replacement PCB if one was available.

To me the more desirable replacement PCB to be had would be the one for the Beomaster 8000 PCB 9 (Microcomputer board).  That board can cause all sorts of problems due to bad connections. 

After that would probably be the PCB 8 (Display board) like Fredrik did back in the archived forum. It plugs into the Microcomputer boards and there are interconnections there that new boards might fix problems with.

The output amplifier boards (PCB 5) is the smaller and easier to try and remake.

-sonavor

Hi

Sooner or later....doesn´t matter when.

Of course you can fix the loose Traces on the Board with som Wire an soldering, but for me it looks not very good even I use some wire end ferrules for through Hole to get a better Stability and to put the Wire around the ferrules to take mechanical stress from the Resistors and Transistors. For me it worked very well, but... we´re all some kind of Perfectionists, so if there is a Possibility why not take new Bords from a better Material?

The Problem is, that there are no Pictures of the PCB´s except the uC Board to find in the Manuals.

Maybe Peter, as a never ending source, has asome Pictures of the Boards in his Manual Archive.

I´ve made a Contact to Mowhawk, took me a little Time but he hasn´t any PCB´s he made since 10 Years ago.

But he promised me that he would have a look if there are the Drawings from the Boards he made.

So we have to wait a while,.

Best Regards

Christian

fkatze wrote:

It might take me a while, it might take me fornever. 

If you run out of steam, let me know.

A number of years ago I bought a company with a few circuit designs that were produced in small quantities.  For one of the boards I had only a handful of blank copies, but not the digital files for fabrication of more.

I paid about $100 to have the PCB reverse-engineered in China to recover the digital assets.  I'm sure I could find the name of the company I used if you're interested in handing off the work to someone else.

(Engineering speak: I paid $100 to have a set of Gerbers created from flatbed scans of a 2-layer PCB.  Resulting files included the full Gerber stack including solder mask and paste layers.  Results were FAR better than I expected for the price.)

Nothing New from Mohawk🙁

I´ve made a scan from the PCB.

Login to view image

It´s mostly original Size.

I´ve made a Layout with a simple Paint Program, but sadly not to Hand at the Moment.

I just draw the Traces and made the Solderpads with a bigger Point, looks not very professional but maybe it works.

Have to mirror the Picture and I´ll buy some PCB for UV Light developing and see what´s happening.

Keep going!

Best Regards

Christian

Hi

Haqd a long Night spending with a simple Drawing Programm.

Ha Ha

just tryed to print this out, much too small and wiht the white spots in the traces.

Sadly the I could not upload the original .ODG File.

I can send it on reqest as a PM if anybody likes.

Best Regards

Christian

send it along...