Help to connect Beolab 11

[RAFA1986]

Hello,I recently bought a BeoLab 11 to add to my BeoLab 8000 setup, which is currently working connected to the TV through a DAC.

What connections and cables should I use to make this change?

I searched here on the forum and didn’t find anything similar to my case. If I didn’t search properly, I apologize for that.

Thank you for the support.

</article>

• This topic was modified 21 hours, 34 minutes ago by RAFA1986.

[Millemis]

I guess this will answer your question.

MM

Location: Flensborg————Danmark

[RAFA1986]

Hi,

Thank you for your answer.  😊

Unfortunately, I found out that if I use the LINE setting on the Beolab 11, the sound won’t come out through the two Power Link interfaces that connect to the Beolab 8000.

The best solution I came up with was to use two 1:2 RCA splitters. Then I connected the L from the Beolab 11 and the L from the Beolab 8000 to the L of the DAC, and the R from the Beolab 11 and the R from the Beolab 8000 to the R of the DAC.As for the cable, I built the 8-pin DIN cable myself (pins 2, 3, and 5), connected from the IN of the Beolab 11 to the two male RCA connectors that go into the splitter, as I mentioned before.

With these connections, everything works. But with this setup I’m facing the problem of a ‘hmmmm’ noise 😑.

• This reply was modified 4 hours, 12 minutes ago by RAFA1986.

[Author]

Posts