Beo5 programming: can I dedicate some commands to separate systems

[Stefan Zueger]

I have a Beoplay V1 TV and a BeoSound 9000 CD player standing next to each other. They share the Beolink speakers via an Almando Multiplay switch, but they have no ML/NL connection with each other.

I have a Beo5 remote with the programming SW. Is there a way I can target remote control commands to dedicated systems?

Example:
If I press “TV”, the command should go to the Beoplay V1.
If I press “CD”, the command should go to the BeoSound 9000.
If I rotate the volume wheel, the command should go to both.

Thank you very much, Stefan

• This topic was modified 8 hours, 43 minutes ago by Stefan Zueger.

Location: Switzerland
Favourite Product: Beosund 9000

[Millemis]

Not that I know of (but I do not know everything 🤗)

What I know is, that it will be possible – and much easier – if you’d use the NL/ML Converter.

MM

Location: Flensborg————Danmark

[YannChris]

Hi,

Assuming that you do not use the 2 product simultaneously (I know nothing about the Almando product):

1: Create a zone for the 9000 and another one for the  V1

2: Move the V1 zone under the 9000 one, so that the 2 zones are considered to be in the same room.

3: Add the 9000 and it’s speakers to the 9000 zone

3b: Set the 9000 to option 1 (right-click on the product’s picture to get the sub-menu, it might be the case as there are 2 sub-zones in the setup)

4: Add the V1 in it’s zone

4b: Set it to option 1

5: Add the logos, etc for each product and go to following screens.

Then, you can pass from one system to another by changing the zone.

Regards,

Yann.

 

 

• This reply was modified 2 hours, 7 minutes ago by YannChris.
• This reply was modified 1 hour, 38 minutes ago by YannChris.
• This reply was modified 1 hour, 32 minutes ago by YannChris.

Location: Brittany, France
My B&O Icons:

[Madskp]

It sounds to me like both the TV and the BS9000 are set to option 2 (receiving both audio and video commands). If you change both to option 1 the V1 will only react to video commands and the BS9000 only to audio commands.

I think that would be the simplest in this setup

I dont know how to do the option settings with a BEO5, but if you have a BEO4 or s Beolink 1000 I can post the instructions

Location: Denmark

[YannChris]

I edited my previous message with a detailed procedure.

Other point: I would delete or hide the sources of the 9000 in the V1 screen and vice-versa.

• This reply was modified 1 hour, 34 minutes ago by YannChris.
• This reply was modified 1 hour, 33 minutes ago by YannChris.

Location: Brittany, France
My B&O Icons:

[Millemis]

Madskp and YannChris

✔️ 😀

MM

Location: Flensborg————Danmark

[Author]

Posts