Home › Forums › Product Discussion & Questions › BeoLab › Beolab 2500
- This topic has 2 replies, 2 voices, and was last updated 11 months ago by Ipe.
-
AuthorPosts
-
28 December 2023 at 05:44 #51626
Hi
Found old Beolab 2500 speakers and they are in very good condition.
except …….
no light, no sound, no nothing…..
Transformators seem to be ok but that’s about it.
Any suggestions or similar experiences??
Ipe
31 December 2023 at 08:59 #51627Ipe:
There should be a red standby led when you plug the unit in.
The powerlink has a 5v trigger which comes from the Beocenters and tells the speaker to turn on at which point the led changes color to green. So for it to play you need to send an audio signal as well as the 5V trigger.
But if you are getting absolutely nothing… start with the power supply. Maybe a fuse?
Is the cord plugged all the way in? The receptacle is in a very awkward location and its not always easy to plug the cord in properly.
Derek
31 December 2023 at 20:21 #51628Yep, I’ve checked fuses etc. Power comes out from transformer but that’s it.
Both speakers the same. Tried to connect those to other B&O devices also with same result.
-
AuthorPosts
- You must be logged in to reply to this topic.