Connecting a Beolab 2 to a Beosound 9000 wireless

[69er]

Hi beoworld,

i am trying to connect an older B&O Speaker (in this case a Beolab2) wireless with a Besosound 9000.
I found a Beolink1 receiver (WISA), which should output to the switched Powerlink, which is needed for the Beolab 2.

But what transmitter could be used to run the Besound 9000 as a source for that signal?

 

Would be thankful for any hint reagrding this problem.

 

Best regards

69er

[Steve at Sounds Heavenly]

Hi 69er,

You will need the B&O Transmitter 1 connected to the 9000, then a B&O Receiver 1 connected to the Beolab 2.  Please use two RJ45 to Powerlink cables for the connections (one for each device):-

https://soundsheavenly.com/bang-olufsen/31-325-rj45-to-powerlink-compatible-all-in-one-cable-convert-new-2013-ethernet-powerlink-to-traditional-8-pin-din-powerlink.html#/9-length-18m

Kind regards, Steve.

Location: The cable workshop, England

Favourite Product: Beosystem 72-23

Signature: Cables, friendly advice and great ideas for connecting Bang & Olufsen! Ask any questions at https://soundsheavenly.com to get the best from your B&O! Please visit my B&O YouTube channel at https://www.youtube.com/soundsheavenlycables

My B&O Icons:

[69er]

Hi Steve,

thank You very much for your help. Much appreciated.

Best regards (from a youtube follower – i learnt so much from your videos)

69er

[Steve at Sounds Heavenly]

Thanks 69er!

Kind regards, Steve.

Location: The cable workshop, England

Favourite Product: Beosystem 72-23

Signature: Cables, friendly advice and great ideas for connecting Bang & Olufsen! Ask any questions at https://soundsheavenly.com to get the best from your B&O! Please visit my B&O YouTube channel at https://www.youtube.com/soundsheavenlycables

My B&O Icons:

[Author]

Posts