BV 3 28 automatic startup?

in General Discussion & Questions · May 12, 2015 19:07 GMT

Thanks for the answers. I have a STB connected via the stb controller but even if the Vision startsup, the STB remains in standby mode. Checked the timer, but this one is switched off. I will be trying the power disconne…

BV 3 28 automatic startup?

in General Discussion & Questions · May 1, 2015 02:28 GMT

Hey fellow Beonerds, I am looking for a solution for my Beovision 3 28's behavioral problems ;-) She started to have a mind of her own with randomly switching herself on from standby. First thought was interference from …

How to... (install STB in BV3-32)

in General Discussion & Questions · Nov 4, 2014 22:27 GMT

Does anyone have any idea on how to get this to function properly?

How to... (install STB in BV3-32)

in General Discussion & Questions · Nov 4, 2014 22:27 GMT

Thanks, yes, disconnected the BV3 from the mains. Fuse seems to be OK The software versions are as follows: 06 IC3 (AP): SW 6.41 06 IC2 (IOP): SW 17.1 32 IC607 (AC3): SW 2.3 EEPROM ver.: 005 Type: 8800

Beomaster 1000 back to life!

in Imported Content (Unmapped) · Nov 3, 2014 21:09 GMT

interesting stuff! Have a couple of vintage beomasters and beolabs 1700 up for overhaul to when I find the time to do so. You think the big caps can still be replaced with new ones? good luck

Beocom 2 charger repair

in General Discussion & Questions · Nov 3, 2014 20:56 GMT

Hi all, Does anyone have an idea how to open the base (charger) station of a beocom 2? Thought the battery was done for, so replaced it with a new set, but still it isn't charging, cleaned the contacts on both phone and …

How to... (install STB in BV3-32)

in General Discussion & Questions · Nov 3, 2014 14:30 GMT

Hi Guys and Girls, Have recently bought a STB controller for my BV3-32 and installed it, but the TV doesn't seem to recognize the STB controller (6pin cable installed on the main control board red top right connector and…