Beovision 4-42 speaker mode HELP Wanted!!!

in General Discussion & Questions · Jan 14, 2010 05:40 GMT

Usually the default can be set using the on screen menu. Did you try it? S.P.

Beosound Century

in General Discussion & Questions · Aug 2, 2009 08:29 GMT

Thank you for your quick reply! Any microphone that is recommended? Thank you again.

Beosound Century

in General Discussion & Questions · Aug 2, 2009 07:47 GMT

Hello everyone ! I recently bought a used Century in very good condition. Works fine but I have two questions. I know I can record on the tape from radio or from the CD. Is there any way to record on the tape a conversat…

Beogram 4500 plater does not turn properly

in BeoGram · Jul 30, 2009 19:01 GMT

Hello again ! Finally I got my 4500 to my local authorized B&O dealer. After all the required checks the problem was clear. You had guessed it. (Martin I think). The subplatter has been deformed. The problem was that dur…

Beogram 4500 plater does not turn properly

in BeoGram · Jul 14, 2009 17:29 GMT

Thank you Martin. I agree with your point. I should be able to get the BG to an authorized B&O service center. Can the subplatter be fixed? or I will need to find another one? I will inform everyone of the outcome. Thank…

Beogram 4500 plater does not turn properly

in BeoGram · Jul 12, 2009 08:54 GMT

Hello again, I tried to adjust the two out of the three (I did not remove the cover yet) screws but no luck. Same behaviour. The platter goes up and down. As a result I think, without being an expert, that the problem is…

Beogram 4500 plater does not turn properly

in BeoGram · Jul 11, 2009 15:52 GMT

Thank you Mika, It seems too risky for me so I have decided to take the BG 4500 to an authorized B&O service center to do it for me here in Athens Greece. Hope the sub platter is not warped and needs only adjusting the l…

Beogram 4500 plater does not turn properly

in BeoGram · Jul 11, 2009 14:29 GMT

Hello again, I just realized that I cannot adjust all three leaf springs? How do I remove the cover in order to reach all three ? Thank you again ! Spiros.

Beogram 4500 plater does not turn properly

in BeoGram · Jul 11, 2009 12:14 GMT

Hello, thank you all for the quick responses. I checked again and the screws are fully open and hanging loose. As you mentioned the platter and arm are bouncing on the leaf springs but the platter is still catching. I wi…

Beogram 4500 plater does not turn properly

in BeoGram · Jul 11, 2009 05:30 GMT

Hello, I am a fan and I have read your valuable advice many times. This is my first question to all of you. I recently bought a used BG 4500. It arrived properly packed and all I did was I uptight the 3 screws at the bot…