beogram 6006 problem

in BeoGram · Dec 11, 2008 14:56 GMT

Welcome back Geoff! The voltages were a little to high but not by much,maybe up to 1 volt.On either the forward or the rewind button(sorry,I don't remember which)even when I ajusted the voltage,it was still a bit(about 8…

beogram 6006 problem

in BeoGram · Dec 1, 2008 17:59 GMT

I CAN'T BELIEVE IT! IT WORKS!! Thank you again for all your support.I've been repairing electronics for twenty years but I have to say that I never could have don this without you.🤩 If you have time,I wish you can expla…

beogram 6006 problem

in BeoGram · Nov 30, 2008 23:41 GMT

Hi Geoff Yes,the motor goes into reverse very slowly and when it stops,there is no change in the coil voltage.It takes about 30 seconds for the arm to back up at total stop. I'll try lubricating at the other point see wh…

beogram 6006 problem

in BeoGram · Nov 28, 2008 20:23 GMT

Hello! I changed the belt and there are some improvements.The carriage now reaches the disc exactly where it should but then,it starts to very slowly back up about a millimeter or two and the arm doesn't want to drop eve…

beogram 6006 problem

in BeoGram · Nov 27, 2008 19:46 GMT

Hi! Is the optical tracking sensor the one that detects the small movement of the needle at the base of the carriage?If so,when I made the arm drop by putting 5 volts on the coil,the arm motor was running slowly and doin…

beogram 6006 problem

in BeoGram · Nov 26, 2008 01:25 GMT

Hi Martin! I removed and cleaned the threaded rod with a degreaser and a toothbrush then I put everything back in place and the arm does move a little further(about 2 mm)but I still have the problem.I decided to try the …

beogram 6006 problem

in BeoGram · Nov 24, 2008 17:58 GMT

Thanks to both of you guys! I just cleaned the threaded rod and lubricated everything but the problem persists.The belt,althought not the triangular type seems to be fine as there is no slippage at all and no dragging.Co…

beogram 6006 problem

in BeoGram · Nov 22, 2008 11:53 GMT

Thanks for replying Geoff! when I press PLAY ,the arm does move close to the edge of the record but stop short of reaching it.Then,I press forward and the arm will go over the record but the play button won't make the ar…

beogram 6006 problem

in BeoGram · Nov 20, 2008 20:32 GMT

I have a beogam 6006 turntable which the arm won't come down on the record.althought the detector arm sends the signal,it just doesn't work.the arm doesn't go to it's place on its own.I have to make it travel with the fo…