Beocenter 9000 cd problem - no sound

in The Workbench · Nov 4, 2011 10:03 GMT

I have soldered some things before, so maybe it could be done. The problem is, like I wrote before, my tech knowledge is bad and I don't quite understand what needs to be resoldered. Could you be a little more specific? …

Beocenter 9000 cd problem - no sound

in The Workbench · Nov 3, 2011 16:08 GMT

My technical knowledge is a bit limited, so I have no idea is it a 14 or 16bit:) I opened the machine up and detached the cd-player. Wires and connectors seemed fine. Then I just cleaned places a bit and closed it. And y…

Beocenter 9000 cd problem - no sound

in The Workbench · Oct 28, 2011 06:39 GMT

Yup, mute relay is out of the question and it has been replaced couple of years ago. Me and my beocenter are located in Finland. Any ideas what could cause this cd-problem?

Beocenter 9000 cd problem - no sound

in The Workbench · Oct 24, 2011 06:18 GMT

Hello, I couldn't find any similar cd problems from this forum (apologies if there is). Here is the problem: Cd-door slides open normally, then closes and cd starts to "play" just normally, except there is no sound at al…

Beocenter 9000 MUTE RELAY??

in The Workbench · Aug 6, 2008 16:34 GMT

Hi, How can I clean/lube my beocenter's mute relay? It has some kind of plastic "shield" and I couldn't get it off because I was afraid that it will break.. :) -Kaa

Beogram TX2 - DATALINK?

in BeoGram · Jul 23, 2008 06:19 GMT

I have the service manual but Im not very good with diagrams.. What is the right place for Datalink cable inside the turntable? I have to be sure before I start. Dont want to break anything..

Beogram TX2 - DATALINK?

in BeoGram · Jul 17, 2008 03:38 GMT

Ok, thank you very much! By the way, what kind of cable it uses?

Beogram TX2 - DATALINK?

in BeoGram · Jul 15, 2008 06:08 GMT

Hello, is it true that TX2 actually has Datalink build in the system but it just isnt in use because of the RCA or DIN5 connectors? (somebody said so:) If so, where can I find Datalink and how should I connect it to DIN7…