4002 cartridge plugs into arm at an angle

in BeoGram · Jan 10, 2026 21:41 GMT

That would be great. How do I order it? I tried sending you a private message, but every time I try, it says I am not logged in.

4002 cartridge plugs into arm at an angle

in BeoGram · Dec 30, 2025 16:37 GMT

Thank-you for the detailed response. Nothing feels loose, I have tried 3 cartridges in this arm that insert and work in another 4002 without any problem. I will try to get a better look at what is going on. Are the 3D pr…

4002 cartridge plugs into arm at an angle

in BeoGram · Dec 29, 2025 17:52 GMT

Thanks Craig, that is a good idea. The first picture shows what appears to be the lower copper spring/prong is bent upwards. The next picture shows the angle of the cartridge plugged in. If the copper spring is my proble…

4002 cartridge plugs into arm at an angle

in BeoGram · Dec 27, 2025 21:45 GMT

I picked up a 4002 with a problem with the arm, the cartridge plugs in at a bit of an angle causing the bottom of the cartridge to drag on the record. Anyone know how to correct this? Thank-you.

RX2 MMC5 tonearm cartridge wiring?

in BeoGram · Dec 17, 2025 22:12 GMT

I am replacing an RX2 arm and need to know the wiring at the end of the turntable. I know what the wiring is for standard 2 x 2 configuration with + on the top, grounds on the bottom. The end of the RX2 is a 2 x 2 config…

Beogram 8000 problem

in BeoGram · Sept 30, 2020 18:18 GMT

Hello Chrischi, Thank-you for your suggestions and encouragement. I did find the problem, which I did cause. Like you suspected, as I replaced one of the capacitors I damaged a pad causing an open circuit to the land in …

Beogram 8000 problem

in BeoGram · Sept 27, 2020 18:26 GMT

I am hoping someone can offer some suggestions regarding the problem I am having with 8000. Thanks to Martin, I replaced the tach disk and caps, the problem that I am left with I have probably caused. When I power the un…

4004 arm not dropping, covers on

in Imported Content (Unmapped) · Nov 27, 2016 03:35 GMT

I have a 400, that I hadn't used in years. I cleaned and lubricated the arm drop mechanism, and it works find with the cover panels off. When I put them on the arm doesn't drop. Does anyone have any suggestions?