Beogram CD 3300 problems

in BeoGram · Apr 21, 2025 20:10 GMT

Hi Nick , Did you solve it ? I have pretty similar issue with my own unit. Thanks, Raf

Beogram CD 3300 doesn't read CD

in BeoGram · Apr 21, 2025 16:17 GMT

Hi Stephane , Did you managed to solve the issue? I have similar problem, however when I am trying to check if there is laser head movement or laser output - there is no movement nor output. Best regards, Raf

Beocenter tape mechanism diagram.

in BeoCenter · Jan 10, 2024 15:00 GMT

Derek, I appreciate your prompt response and the diagram you provided. However, I've successfully resolved the issue on my own. I hope you were able to address the issue on your end as well. Upon installing new belts, I …

Beocenter tape mechanism diagram.

in BeoCenter · Dec 16, 2023 20:58 GMT

Dear Steffen, I appreciate your prompt response. I attempted to download the service manual from the main page, but unfortunately, there is no Beocenter 8000 service manual available. I downloaded a service manual from t…

Beocenter tape mechanism diagram.

in BeoCenter · Dec 11, 2023 12:27 GMT

Hello, could anyone who has a Beocenter 8000 tape mechanism belt diagram could share it with me please. Please see attached pic. with the mechanism. Thank you.

Master Control Panel 5500 Flickering

in Imported Content (Unmapped) · Apr 3, 2021 18:27 GMT

Hello, I bought MCP5500, once batteries were installed I discovered that all features on the display are flickering. I I did try with different set of batteries and also connected it directly to power supply ( no luck - …

Beocord 3500 closing lid issue

in General Discussion & Questions · Dec 26, 2020 13:29 GMT

Hello, Beocord 3500m - when pressing LOAD it open smoothly, when I pressing again it is starts closing the lid and stop after a second(power cut to the lid motor), when I pressing again it is open the lid and when I pres…

Beogram CDX 2 spins anticlockwise

in General Discussion & Questions · Dec 26, 2020 12:59 GMT

Hello, I have CDX 2 with unusual behaviour, cd pins anticlockwise- it is start right way for maybe one second and then start spinning wrong way. I replaced electrolytic capacitors( 2x 220uF, 2x47uF,33uF)on the servo boar…

Beocord 3500 - tape deck alignment - help needed

in General Discussion & Questions · Dec 17, 2020 19:22 GMT

CDX no sound -griplets?

in Imported Content (Unmapped) · Jun 24, 2020 22:20 GMT

Thanks for quick response, I have re-soldered the joints of those elements and CDX is back to life 😁

CDX no sound -griplets?

in Imported Content (Unmapped) · Jun 24, 2020 22:15 GMT

Thanks for quick answer, I have re soldered joints of those elements and CDx is back to life :)

CDX no sound -griplets?

in Imported Content (Unmapped) · Jun 24, 2020 22:15 GMT

Thanks for quick answer, I have re soldered joints of those elements and CDx is back to life :)

CDX no sound -griplets?

in Imported Content (Unmapped) · Jun 23, 2020 22:38 GMT

Hello , Sorry for being a pain and refresh the post( I have same issue with my CDX) Where can I locate mute relay? Thank you.

CDX no sound -griplets?

in Imported Content (Unmapped) · Jun 23, 2020 22:38 GMT

Hello , Sorry for being a pain and refresh the post( I have same issue with my CDX) Where can I locate mute relay? Thank you.