Dead Beocenter 9300

in Imported Content (Unmapped) · Aug 4, 2020 18:00 GMT

Hi BeoBeo My 9300 looks to have suffered the same problem. No life and the PCB tracks from the F1 output from the standby transformer have burnt through. The resistance of the coil is measuring 0.2 ohm across the F1 lead…

Beogram 6500 Issues

in BeoGram · Nov 15, 2019 18:29 GMT

Thank you all. The knot does appear to be in the correct place. The 17cm put down is similarly sliding off the record even at the extreme of adjustment. Perhaps if I remove and re-thread the cord it may have an effect- i…

Beogram 6500 Issues

in BeoGram · Nov 12, 2019 17:15 GMT

Yes it does adjust the setdown point. When the spring is short the setdown is about 4 or 5mm before the record start. At its longest length the setdown is just at the start, but falls of about 1 in 10!

Beogram 6500 Issues

in BeoGram · Nov 12, 2019 14:56 GMT

Thank you Martin. That would certainly explain what I'm seeing. However I've double checked and the peg does not appear to be about to break. I've taken a photo to show what I see...

Beogram 6500 Issues

in BeoGram · Nov 12, 2019 11:21 GMT

Hi Tsjoechov, Did you manage to fix your problem. I have a beogram 5005 and the tone arm can be adjusted so that it just (and only just) reaches the edge of the LP. I would like it to go a mm or so further but there is n…

Beocenter 2200 tape stopping

in General Discussion & Questions · May 18, 2019 12:02 GMT

I'm new to the forum so not sure if this should be started here.. but I have recently acquired a beocenter 2200 which is all working fine apart from the tape. The cassette belts are in good order, but it is behaving very…

B & O BEOCENTER 2200 PROBLEMS: TAPE PLAY & THE COUNTER

in General Discussion & Questions · May 6, 2019 21:28 GMT

Hi. I'm new to this forum so not sure if I should start a new thread or just reply here. I have a beocenter 2200 and the cassette is behaving very strangely. It will play, RR or FF fine- but only for about 2 secs, then i…