Posts by BeoGrad
12 total posts9 results
Beolab 6000 impressions and questions
in General Discussion & Questions · Feb 22, 2022 22:08Welcome back, Beoworld. 🙂 I have rebuilt one Beolab just to try: replaced sponge lining, bungs and double-sided gasket tape, all locally sourced. I also did clean the contacts and matched bass and treble levels to 2.80V…
Beolab 6000 impressions and questions
in General Discussion & Questions · Feb 17, 2022 19:26So, I went inside to check the overall condition of electronics and damping lining. While the elctronics is in very good condition (all Elna capacitors are well within spec), the foam linings and bungs have crumbled and …
Beolab 6000 impressions and questions
in General Discussion & Questions · Feb 7, 2022 19:03Hello from a long-time-no-see member. I have purchased a pair of pre-owned Beolab 6000s (1992) for my living room. My first impression is that they perfectly fulfil their promise: they blend seamlessly into interior and …
Beomaster 2400 muting always ON
in Imported Content (Unmapped) · Feb 7, 2015 11:44Hello Martin and thanks to your reply. The lamp is OK and the whole volume control works: namely, the IL1FAULT circuit is not active, the volume sensors respond and do not pull volume back to zero. My question is if -12V…
Beomaster 2400 muting always ON
in Imported Content (Unmapped) · Feb 7, 2015 11:43Hello Martin and thanks to your reply. The lamp is OK and the whole volume control works: namely, the IL1FAULT circuit is not active, the volume sensors respond and do not pull volume back to zero. My question is if -12V…
Beomaster 2400 muting always ON
in Imported Content (Unmapped) · Feb 4, 2015 23:22Dear Beoworld fellows, this is my first login and post after more than 10 years - the stuff has been working greatly up until recently when my Beomaster 2400 developed a fault. All touch commands work function without pr…
Beomaster 2400-2: 3 electrical problems after refurbishing
in The Workbench · Mar 28, 2009 16:29Good evening again, no improvement here. I've replaced the rectifier on PCB2, the adjacent 2200 uF cap (although I had replaced it already) and adjusted 15V regulated supply and tuning voltages. Same symptoms as before. …
Beomaster 2400-2: 3 electrical problems after refurbishing
in The Workbench · Mar 23, 2009 15:54Hello Martin, good to see you again. Thanks for the advice. I'll let you know my findings, probably not sooner than the coming weekend. M.
Beomaster 2400-2: 3 electrical problems after refurbishing
in The Workbench · Mar 23, 2009 08:11Hello from the ex-moderator of the Italian forum, I have recently refurbished my Beomaster 2400-2: replaced all electrolytic caps and trimpots, did the resoldering and final adjustments. Sonically it is flawless, however…